Showing posts with label mount. Show all posts
Showing posts with label mount. Show all posts

Wednesday, December 4, 2013

Brain Cortex Spirit Thermometer Install Part 47

Thermometer locates between two power units
BRAIN CORTEX SPIRIT THER- MOMETER INSTALL 

PART 47

Position black and red wires behind the thermometer
It's important to monitor the jar's core battery temperature status when recharging. This inexpensive and simple solution will do just that!

At the moment batteries become warm during the charging process, it's an indication the charging process is complete.

It may also indicate that the trickle charger is trickling too much and adjustment to the charging power grid is required.

Unit is next to the solar panel grid
This blog details the installation of a low cost small spirit thermometer inside the Brain Cortex jar. The thermometer is placed in a position, opposite the electric thermometer and lower in between two twin power units to read their heat signature.

The position of the single spirit thermometer is a drop down in between the corners of two twin power units.

The spirit filled traditional small thermometer has ~ -30 to +50 degree Centigrade scale, intended for food freezer use. The unit is part number G-590. The glass tube is the same length as a 1.5-volt D-size battery. 

It has a scale in one degree increments. The goal is to attach or place this thermometer to the proximity of a battery and monitor the charging temperature during the charging process, and continuously monitor the battery temperature to assure everything is nominal.

Accurate reading of the tiny scale may need a magnifier
The thermometer can stay mounted inside the jar, remaining with close contact with a single battery for continuous monitoring and inspections.

The analog temperature will be read through the transparent jar by visual inspection, as the unit is placed in contact with the interior transparent jar wall.

Early tests show the higher mounted electric thermometer reading 73 degrees Fahrenheit and the spirit thermometer, which contacts the jar floor, reading 72 degrees Fahrenheit, a nominal temperature difference of 1 degree due to the strata positioning.

Like other traditional thermometers of this type, there is no maintenance. Purchaed from a dollar store, at more than a dollar, the cost was NT$85. The thermometer may be purchased at this source: http://www.double-sun.com.tw

The spirit thermometer can be used in tandem with the electric thermometer, obtaining a cross gradient and cross section of battery and jar room temperature, for better assessment of the jar's Eco-environment.

Principle concern is for the electronics, especially the Parallax Propeller chip which is rated at a median temperature of 50 C during tests according the to specification sheet.

There is a meltdown jar temperature and this limit may be reached long before the Propeller chip upper limit is reached.

LINKS
Index to the Brain Cortex
http://humanoidolabs.blogspot.tw/2013/11/brain-cortex-index-part-16.html
Thermometers
http://humanoidolabs.blogspot.tw/2013/10/brain-cortex-thermometers-part-9.html
Electric Thermometer Source
http://www.double-sun.com.tw

Saturday, November 30, 2013

Brain Cortex Update Part 43

Brain Cortex is shaping up very nicely in November
BRAIN CORTEX UPDATE PART 43 

NOVEMBER 2013
The machine brain in a jar now is beginning to take shape, and includes the power mounts and the power solar panel ready for wiring. The new design uses a twin stacking of battery holders mounted directly onto the interior jar wall. Each series stack delivers 3 volts to the Propeller chip circuit.
It's time to wire the twin holders series connections

The next step is more testing and wiring phase I. It's uncertain as the extent of the control panel, or will the brain be entirely on auto pilot, managing itself.

The route of the control panel may include the voltage monitor, the temperature and humidity monitor, and various switchable modes between battery and solar panel operations, the status of charging, no charging, and various energy modes. Positioning the thermometer is critical to determine the battery supply heat level at all times inclusive of charging. Humidity will be monitored as part of the Desiccator which removes moisture from the air inside the jar.

A next step is wiring all right hand sides of the battery holders, joining black to white with a yellow twist. This produces the twin pack's series connection, creating three volts to operate the propeller chip. The space in the corners of the holders is available for additional battery holders. This could supply the digital meter that reads the power level.

ABOUT THE CORTEX
The cerebral cortex is the outermost layered structure of neural tissue of the cerebrum (brain), in humans and some other vertebrates. It covers the cerebrum, and is divided into two cortices, covering the left and right cerebral hemispheres. The medial longitudinal fissure is a deep groove that separates these two hemispheres. The cerebral cortex plays a key role in memory, attention, perceptual awareness, thought, language, and consciousness. It consists of up to six horizontal layers, each with a different composition in terms of neurons and connectivity. The human cerebral cortex is 2 to 4 millimetres (0.079 to 0.16 in) thick.

PROJECT OBJECTIVES
The project objective is to develop a cortex machine brain, demonstrate human-to-machine brain transfer, in particular to take some relatively simple human characteristics and transfer portions to the machine brain, whereby human traits could be given greater life longevity, leading towards immortality. 

LINKS & CREDITS
http://en.wikipedia.org/wiki/Cerebral_cortex
http://en.wikipedia.org/wiki/Vertebrate
http://biology.about.com/od/anatomy/a/aa032505a.htm

BRAIN CORTEX INDEX
http://humanoidolabs.blogspot.tw/2013/11/brain-cortex-index-part-16.html

Brain Cortex Solar Panel Install Part 41

BRAIN CORTEX SOLAR PANEL INSTALL PART 41

The Cortex solar panel was installed inside the brain jar above the power unit's top level. The bottom of the panel is fit to the top ledge of the battery holder, which holds the bottom of the solar panel in place without any hardware. The top of the solar panel has two angle brackets holding it, connected together as shown. The back side of the solar panel has a sticky substance which nicely grips the angle bracket's long extension side. It can also serve as a wire holder as shown.

This is the larger solar panel rated at 3 volts and 120 mA designed to power the brain and trickle charge the batteries during the day. Tests show the panel works in available room lighting.

Index to the Brain Cortex
http://humanoidolabs.blogspot.tw/2013/11/brain-cortex-index-part-16.html

Tuesday, July 2, 2013

Radio Telescope Observatory Lab 58

RADIO TELESCOPE OBSERVATORY LABORATORY 58

LOOKING FOR ET
A radio telescope laboratory is in the works at the Asian Arena International Taiwan location, being built as part of the open sky-faced balcony radio observatory BRO project. The purpose of the radio telescope is to observe radio sources, particularly the Sun and the planet Jupiter, as well as any signals that may be of extraterrestrial origin.

LOCATION
Taiwan is an island favorably faced by ocean on all sides - the South China Sea, the East China sea, and the Pacific Ocean. This water is uninhabited and creates a surrounding zone of quiet radio, more than a land surrounded counterpart. Taiwan has the greatest zones of uninhabited ocean space to the North towards Japan and to the east leading out into the deep ocean. Ideally situated is the city of Taipei to the extreme North of Taiwan that takes advantages of these oceanic voids.

EQUIPMENT
The equipment deploys a decametric 10-band radio receiver and a custom constructed antenna designed to match the correct frequency or to engage in a tunable sweep. Additional components include an electronic computerized strip chart recorder which handles the signals fed through the computer's sound card, and a DVM for numerical output, plus an audio buffer to match the signals to the equipment. Additionally, audio out permits one to listen to the actual signal for tuning and signal acquisition. This also helps in the case of guiding on moveable objects like satellites, spy planes, military vehicles, and alien spacecraft should one make a dramatic entrance into air space.

ANTENNA
It's planned the antenna will have a moveable scaled mounting to be able to track both natural and artificial sources, including satellites and aircraft. As part of a Tiny SETI Program, the mount will move to track anomalous sources which could be of extraterrestrial origin.

FIRST CONTACT FREQUENCY
We don't necessarily subscribe to the notion that first contact will result in the microwave spectrum. We believe other broadband frequencies may be used for wide spectrum first contact. Our deepest belief is that advanced aliens would use a technology for transmitting and receiving particles which we are currently not aware of.

DETECTING ALIEN CIVILIZATIONS
This radio observatory could tap into an alien civilization which is evolving around a star, given its radio signature is bright enough to be seen by the equipment. So this technique of First Contact uses this method which first detects their TV, radio, and other sources of activity. This is a viable program that could examine closer star systems in the North from East to West in scans, as recently planets around stars were discovered as close as a hundred light years away that reside in the habitat zone where it is believed that life could be supported.

THE APPEARANCE OF ALIENS
Most of these detected planets are quite large, having their detection based on the gravity wobble influencing its star. The intense gravity on these planets would evolve very large life which is able to cope with great gravity. Our technique is indicative of detecting radio bright planets and not directly observing the stars. So these planets detected could be very small but exhibiting very bright radio signatures. 

PHONE HOME
In this setup, it's ET who needs to phone us as we have the receiver. We are not going to transmit any signals or give out our location position indicating that any intelligent edible life may live on Earth. The problem is that predator ET may live out there and want to eat us. The Asian Arena International Taiwan Radio Open Sky-faced Balcony Observatory Laboratory 58 is ideal to mask our identity with only one way communications from the aliens to the Earth. 

BUDGET
So far, the project has spent a total of about $10 for the multi-band tunable receiver. The antenna is in the works. The software is Mac based and free. The computer is the Big Brain already in operation. The buffer will be constructed. The DVM is already in the lab. Additional software may be provided by the BIG Brain using Propeller chip technology. It's possible other software will be programmed and written on a supporting iMac computer. Our budget, not counting the equipment already on hand, is under $50. A target goal would be $25. Operating budget would ideally run at about $5 a month for supplies and materials.

R&D
The Asian Arena International Taiwan Radio Open Sky-faced Balcony Observatory Laboratory 58 will be heavy into Research and Development, and the collection & analysis of observational data.